1.10
ENG_UD27229_5
Charge batterie (X09 - Renault)ENG_NU_913-3_X09_Renault_1
ELECTRIC VEHICLE: charging (4/5)
Recharging the traction
battery
Ignition switched off:
– open flap 3;
– take out the entire charging cord 2
located in the storage compartment
at the front of your vehicle, pulling it
by the plug using reasonable force.
The maximum length of the charging
cord is approximately 3 metres;
– plug in the end of the cord to the
power supply (domestic plug socket,
etc);
– make sure that the stretch limiter 8 of
the charging cord 2 is not exceeded
during charging.
NB:
It is not necessary to wait:
– until you reach reserve levels in
order to recharge your vehicle;
– for a full charge of the traction bat-
tery in order to use the vehicle.
3
2
When charging, make sure that the
charging cord 2 is not overstretched.
Do not pull the vehicle using the
charging cord.
If the stretch limiter 8 is damaged,
please replace the charging cord.
Please contact an authorised dealer.
4
5
6
7
When charging, the following informa-
tion is displayed:
– warning light 4. This flashes to indi-
cate that the traction battery is re-
ceiving energy;
– the completed charge percentage 5;
– warning light 6 indicates that the
cord is attached to the power supply;
– the battery 7 indicates the amount of
energy stored in the traction battery.
At the end of a full charge, the instru-
ment panel switches off.
8
2
Comments to this Manuals